WWW.RLYACHTS.NET
RL24, RL28, and RL34 Trailable Yachts
from Rob Legg Yachts

RL Yacht Owner's Discussion Forum

Return to the Forum List

Swing keel raising RL24
My 24 has a very rusty keel raising winch which needs replacing but...

I would much rather install the block system which is described on this site in the diagrams section. However, I have contacted Ronstan and asked them to suggest current part numbers for the parts listed on the diagram but they cannot suggest alternatives.

Does anybody have part numbers, or just a photo of their set up, or suggestions for the appropraite blocks to use.

Thanks!
Tim17-Nov-2008    Edit    Delete 
Re: Swing keel raising RL24
hi if thats tim from WA give me a ring or pop round i can give you set up for your keel i also have that mast raising setup for you just been too busy with work
greg
greg18-Nov-2008    Edit    Delete 
Re: Swing keel raising RL24
Thanks Greg, unfortunately I'm Tim from Brisbane... but do still feel free to pop over if you like!

Best,
Tim
Tim19-Nov-2008    Edit    Delete 
Re: Swing keel raising RL24
Tim, if you can print or copy the diagram shown and take it to Muir Marine at Manly (qld) I'm sure Ross or Jason will be able to come up with somthing to suit. ( maybe not the cheapest solution, but they do know their oats ).( pommy saying).
Good luck,
Martyn
Martyn1-Dec-2008    Edit    Delete 
Re: Swing keel raising RL24
Tim

I have a block system on y Mark 1. It uses simple triple blocks and a cam cleat mounted under the cabin roof. Email me chris.conley@mac.com and I can send some photos.

its damn simple and it works for me
Chris Conley6-Dec-2008    Edit    Delete 
Re: Swing keel raising RL24
On our mark 3 we have a 7:1 system, 2 double blocks mounted inside the cabin top beside the mast support post and a triple block with becket attached to the top of the keel lift wire.
Current part #'s for the doubles are RF50200 and the treble RF 50210.
The 4 mm s/s wire passes through a sheave box, RF41712 or RF 31712 on the top of the centre case.
The lift rope passes through a dead eye on the cabin bulkhead and cleats in a clamcleat.
It works a treat.
email me hartships@spin.net.au if you would like pics.
mike10-Dec-2008    Edit    Delete 

Return to the Forum List       Add a message to this discussion