WWW.RLYACHTS.NET
RL24, RL28, and RL34 Trailable Yachts
from Rob Legg Yachts

RL Yacht Owner's Discussion Forum

Your Name:
Email Address:
Password: ( Needed to edit or delete this message.)
Message Title:
Text of Message:
Add an Image:
An image can also be attached to this listing. Click "Browse" to select the image file on your PC. It can be a JPEG or a GIF file. The file will be uploaded to the server, scaled to fit, and will appear beside the entry.


Replying to:TRAILER MODIFICATIONS - KINGSLEY & KAY WHITE
Dear Kingsley and Kay, I am experiencing difficulty in launching my RL24. A brief background is that I used to launch by floating AWOL off the trailer but the saltwater corrosion resulted in a major refurb of the trailer. I resolved to prevent a re-occurrence of the problem so was determined to use the tilt mechanism and keep the trailer dry. The first attempt a few months ago was unsuccessful so I was forced to float the yacht off. Advice was offered and I ensured all rollers were spinning freely (two secondary side rollers were not). I followed Greg's (INMA)advice of lowering the rear end of the lateral side supports on the latest attempt. The trailer tilted but still it would not slide off. The keel was right up, all rollers serviceable and the side supports sloped towards the rear as Greg recommended. After much pushing and shoving, backward/forward/braking with the Toyota I finally got it into the water. It was yet another hassle associated with single handed yacht preparation. I can only think that the rollers are not aligned properly and I'll have to examine that aspect. Perhaps it is the gentle sloping ramp I use. However, when I saw your launching system for Rings-n-things it seemed to be the solution for me. It appears that you simply winch your yacht off the trailer effortlessly. I understand the principle made more easily understood by the photo of the rear trailer turning block but I have not got my mind completely around the setup at the winch post / electric winch end of the trailer. Would you be able to provide either a photo or a simple sketch which shows the turning block system at the winch post as well as how the rope connects to the recovery 'U' Bolt at the front of the boat? Is it that the rope goes from the 'U" Bolt horizontally to a turning block thence vertically to the winch, thence rearward under the yacht? Or is it that the rope connects to the 'U' Bolt, runs downward along the side of the yacht (and rubbing the bow) until it eventually goes under the yacht? This attempt to express myself will indicate that I have difficulty in comprehending your system fully. Any advice will be gratefully appreciated. Best wishes, Terry